framing and planning

The picture associated with this post shows the joining we used to connect our 6 x 6 timbers as well as the angle bracing we employed. The beams are all oak and the angle braces are Cherry from a tree that my wife and I timbered this Winter. For the environmentally concerned, the tree was standing dead. It was killed by invasive English Ivy planted on an old city lot. The house long ago burned though the landscape plants survived and spread unchecked to kill over forty trees. Much of this house is constructed of those unfortunate trees. The poplar subfloor, the cherry bracing, the pear roof purlins are all a direct result of some 1920s city dweller planting a tiny little English Ivy plant. I am not sure whether to be grateful for the lumber or remorseful for the lose of mountainside forest. 

Back on topic, The upstairs floor is supported by oak 4x4 beams resting atop the 6 x 6 beams. The space created between would be excellent for storing dust bunnies but we plan to use the space atop the beams for recessed lighting. Depending on conditions once we move into the house we may run one inch ridged foam in the space to to dampen sound transfer between floors. Lets be honest its 400 square feet foam or not there is going to be sound transfer. The other thing the gap above the 6 x 6 beams affords us is the ability to run a couple of low profile air ducts. Currently we do not plan to run A/C but if the day comes that we do desire a flush of icy air in mid August then we will be prepared to run the duct work. Once all of these things are completed; wiring, duct work, foam, we will install a vice wood plank ceiling. We will not be using any drywall in the construction of this house or at least that is the plan. We will have painted wood walls, stained walls, concrete walls but no drywall. It is a small enough space to cover that we thought we would forgo the easy and normal and opt for something different. 

Inside

Here is a photo of the house in a stage of partial completion as seen from up the hill. It really is tucked into the wood nicely. We cleared the understory and fire ladder to allow for good air flow through the forest as well as excellent forest floor walking area. 

 And now for the first photos of the inside of the house. This photo to the left is taken from the corner of the living area where the wood stove will sit. The photo is looking into the kitchen area, South, The french doors will be just to the left of this photo and the stairs will ascend in the right of the photo frame, where the boards are leaning.

This photo looks out at the kitchen and living area as well. The window on the West wall denotes the location where the stairs will start. The wood stove will be placed just to the right of the red broom handle. The 4x4 beam in the foreground of this shot is a door post into the bathroom, which I am standing in. 

This photo is looking North. The air compressor ( which we have used for exactly 12  finish nails into the windows, all other nails where hand driven) is about there the wood stove will sit. The opening on the right of the shot is for the french doors. The 4x4 post denotes the entry into the bathroom. The bathroom will have a small step up which will help delineate the space. We used poplar for the subfloor and all of the sheeting on the outside of the house has been free oak and pine from the sawmill. The blue tarp hanging down from the second floor is hanging through the hole where the chimney pipe will go. I have left an area open in the floor for easy access as I am yet to get under the house and do plumbing. electrical, etc. . .